FLY TIPS

1. Quadcopter and remote control are not pairing.

(1) Confirm that both Quadcopter and remote control are both powered on. (2) Rebind the Quadcopter to its remote control.

2. Cannot arm motors.

(1) Make sure that you have completed compass calibration. (2) Check that the Return to Home switch is pointing down/off. (3) Be sure that you are pulling both sticks down out. Check the channels on the screen and verify that they are moving properly (If they are not, please perform a transmitter stick calibration). (4) If you are flying indoors, please set the "Fly With No GPS" option on the Main Menu from the default "No" to "Yes".

3. The drone flies erratically in Altitude Hold mode.

(1) Check to see if the air pressure sensor reading (Altitude telemetry value) is abnormal when the Quadcopter is motionless on flat ground. It should read 0 and fluctuate very little. (2) Check to see if the throttle joystick channel is moving appropriately and properly centred. If not, please calibrate the transmitter sticks and adjust the channel with the corresponding trim button (located on the transmitter).

4. No video on the screen or user is experiencing strong video feed interference.

(1) Rebind the copter to the transmitter, as the 5.8 and 2.4 frequencies might be interfering with each other. (2) The video reception depends on the 5.8GHz radio which is sensitive to the environment, So you can change the 5.8Ghz frequency of the remote control to improve this problem.(3)Test Mode: Press the video button and power on the remote control to enter the test mode, in test mode, you can see the data of 2.4Ghz and 5.8Ghz, if the value of 5.8Ghz is less than 56, the 5.8Ghz image transmission signal is weak, 90~160, the 5.8Ghz image transmission signal is strong.

5. The SD card can't record the video or photo.

(1) Make sure if the SD card is distinguished. If there is an exclamation mark, the card doesn't be distinguished. The card must be replaced.(2) Format SD card, the Allocation unit size should be 32 kilobytes, The Volume label is blank.

6. The remote control display shows "CHECK GYRO SENS".

In this situation,this means that the drone is now detecting whether the gyroscope is stable. You can do as this to solve this problem:1) Check if the drone is on a fixed level or on the ground; 2) If Step 1 can't resolve, update the latest flight control firmware; 3) The above solution can’t resolve it, open the plane to check if the sponge is posted correctly; 4) If step 3 make sure that the sponge is posted correctly, we have to change the flight control board or small pressure plate.

What is Amazon Prime?

For £7.99/month, Amazon Prime members can:

• Access unlimited, FREE One-Day Delivery on millions of items and same-day delivery in select residential postcodes
• Enjoy unlimited instant streaming of thousands of movies and TV shows, through Prime Video
• Read as much as they want from a rotating selection of more than a thousand books, recent magazine issues, comics, Kindle singles, and more, on any device at any time
• Securely store an unlimited amount of photos with anywhere access through Prime Photos
• Listen to over two million songs on Prime Music
• Get exclusive, early access to daily Lightning Deals